頁面 8, Receiver vfd interface, Display panel and buttons – MIPRO ACT-51 Single-Channel Diversity Receiver User Manual

Page 8: Receiver parameters, Group setting grp

Advertising
background image

RECEIVER VFD INTERFACE

Displays all Parameters

Working Frequency

4

Transmitter Battery Meter

8

10

Audio Signal Meter

2

Interference Indicator (lit denotes presence of interference)

6

Preset Channels (can be programmed)

1

RF Signal Meter

5

Squelch Meter (levels can be programmed)

9

Group (can be programmed)

Diversity A/B Antenna

3

Working Channel

7

AF

A

B

1

2

3

4

5

6

7

8

SQ

MHz

GRP

BAT

ACT

MENU

Display Panel and Buttons

10

11

Diversity Receivers

Diversity Receivers

5

4

3

2

8

7

9

6

AF

A

1

2

3

4

5

7

8

SQ

MHz

GRP

BAT

6

1

10

Receiver Parameters

3 parameters can be selected and programmed by the button.

See instructions below:

MENU button: To set receiver parameter values

MENU

GROUP setting

GRP

AF

A

1

2

3

4

5

6

7

8

SQ

MHz

GRP

BAT

Blinking GRP cursor

ACT

MENU

Press once to increase
by one group

Press once to decrease
by one group

Press Once

Instructions:

1.

Press and release the button once. The ----GRP---- cursor starts blinking to
denote it is ready to accept parameter changes.

2.

During blinking, press or button to one of the 6 groups.

3.

Press and release the button once to confirm the change. The ----GRP----
cursor stops blinking and the new group is now stored into memory.

To exit GRP mode:

1.

GRP mode deactivates automatically if or button is not pressed within 5
seconds. The VFD panel dims automatically, too.

MENU

MENU

Advertising