KEMP VMware Workstation and Player - Manual (Page 17)

Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 17 / 19
VLM for VMware Workstation and Player
Installation Guide
Figure 4-3: Nameserver IP addresses
4. Enter a space-separated list of nameserver IP addresses.
5. A message will appear asking to continue licensing via the WUI. Try to access the IP address
via a web browser. Ensure to enter https:// before the IP address.
6. Contact the local KEMP Customer Services Representative for further support if needed.
4.2 Static MAC Addresses Must Be Configured
In case you move a VLM system to a different Virtual Machine, ensure that the MAC addresses
of the Virtual Machine’s NICs stay the same. It is recommended to configure static MAC
addresses for all NICs within Virtual Machines.
For further information on configuring static MAC addresses, please refer to the relevant
VMware documentation.
4.3 Factory Reset
If you perform a factory reset on your VLM, all configuration data, including the VLM’s IP address
is deleted. During the subsequent reboot the VLM attempts to obtain an IP address via DHCP. If
the VLM is on a different subnet to the DHCP server then an IP address will not be obtained and
the IP address is set to the default 192.168.1.101.
The VLM may not be accessible using this address. If this is the case then you must run through
the quick setup via the console as described in Section 4.1.