MEGUIAR'S D149 - Manual (Page 4)

D149, Quik Interior Detailer (23-07A): D14901, D14905
__________________________________________________________________________________________
Page: 4 of 11
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Propan-2-ol 67-63-0 Health and
Safety Comm.
(UK) TWA:999 mg/m³(400
ppm);STEL:1250 mg/m³(500
ppm)
Propanol, 1(or 2)-(2-
methoxymethylethoxy)-, acetate 88917-22-0 Manufacturer
determined
TWA:100 ppm;STEL:150 ppm Skin Notation
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
As a good industrial hygiene practice:
Wear eye/face protection.
The following eye protection(s) are recommended: Safety glasses with side shields.
Skin/hand protection
Skin protection is not required.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Slight flowery fragrance; Clear, water-like liquid.
pH 7 - 8
Boiling point/boiling range 100 ºC
Melting point Not applicable.