Minka Group F689-WH - Manual (Page 18)

OPERATING THE REMOTE CONTROL/WALL CONTROL
Remote Control only:Install a A23,12 Volt battery(included.)To prevent damage to transmitter remove the battery if not used for long periods of time.
Restone Power to ceiling Fan.
A. Buttons:
These buttons are used to set the fan speeds as follows;
=Low Speed
=Medium Speed
=High speed
B. Button:
This button turns the fan off.
9
C. Button:
Press and release the button for the desired light
to turn the light ON or OFF. Press and hold the
button to set the desired light brightness. The
light will cycle between bright and dim setting as
long as the button is pressed.The light key has an
automatic auto-resume feature that allows the
light to remain at the same brightness as the last
time it was turned off.
D.OFF-ON Slide Button(Wall Control
fans Only)
This button turns the power Off and
On to the fan and light(s).
E. Button :(Full Function Remote
Control Units Only)
This button is used to change the
direction of the rotation of the
blades:forward for warm weather or
reverse for cool weather.
NOTE:If your Remote Control or wall
control does not have a” ” button,
please look for a slide reverse switch
on the motor housing.
Please note: If using light kit Model K9380 or any
other Light kit which uses CFL bulbs your Dimming
function will be disabled