Minka Group F803-SL - Manual (Page 19)

10
Fig. 19
NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or
removing the fuse at fuse box.
1. Loosen the 3 screws from the mounting plate.
2. Raise and hold the light plate close to the mounting plate and proceed to do the wire connections.
Connect the white wire connectors from the light plate and fan, follow the same procedure with the
black wire connectors. (Fig. 19)
3. Place the key holes on the light plate over the 3 screws previously loosened from the mounting
plate, turn light plate until it locks in place at the narrow section of the key holes. Secure by
tightening the 3 screws previously loosened. (Fig. 19).
INSTALLING THE LIGHT PLATE
SCREWS
LIGHT PLATE
CONNECTORS MOUNTING PLATE