Martin Universal Design 92-AE122 Torino Aluminum Easel - Manual

Torino
Aluminum Easel Assembly Instructions (page 1)
Carton Contains:
[A] Easel, [B] Adjustment Knobs, [C] Lower Canvas Support (large)
and [D] Upper Canvas Support (small)
Martin/F. Weber Co., Detroit, MI USA
www.weberart.com
Email: [email protected]
Made in China
Step 1.
Empty contents of carton. Remove all plastic
packaging.
Step 2.
Make sure all parts are included.
Call 1-313-895-0700 if any parts are missing.
See Parts List above.
Step 3.
Take Easel [A] and pull out (spread) the side
legs. Loosen knob on rear tilting leg and tilt rear
leg so that tilting brackets reach knob on lower
portion of rear leg. See FIG 1.
Step 4.
Position tilting brackets over bolt going through
lower part of leg. See FIG 2. Tighten knob at
desired angle.
FIG 1
Tilting Brackets Knob Rear Leg
FIG 2
Part B
[2] Adjustment Knobs
with T-Bolts attached
Part C
[1] Lower Canvas Tray
with Palette Holders
Part D
[1] Upper Canvas Support
Part A
[1] Easel
Item No. 92-AE122
Revised 09/06
[A]
If you have any questions or difficulties
assembling this easel.
Please call our Customer Service Hotline
at: (313)895-0700
Go to page 2 for additional instructions.