Troubleshooting – Audiovox PROV 710 P User Manual
Page 10
Troubleshooting:
SYMPTOM:
No power at Video Monitor
Power but no video or
sound
Picture, but no sound
No Infrared remote func-
tions for VCP (or other com-
ponents)
REMEDY:
-Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor.
Verify ground connection with continuity test from known good ground to
black wire at 2 pin Power Harness
-Verify that the correct source is selected (i.e.:1,2,3 or 4). Verify that the
source is on and playing a known good media (such as a DVD or video-
tape). Verify connections at both ends of the source component harness.
- Verify all connections per the wiring diagram on page 6 .
-Check batteries in the hand held remote. Verify that the IR LED ( page 6
Wiring Diagram) is properly attached to the sensor window of the VCP (or
other component).
Negative Switched Dome lighting
To 12 pin
connector
To
constant
To
constant
Factory Door ajar
switch or Body
Factory Dome light circuit
Red / black - Lamp on
Black / red - Lamp common
Violet / brown - Lamp Auto
-8-