Glastender LLD3 - Manual

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
© 2009 Glastender, Inc. 02-05-14
IMPORTANT!!
No labor warranty. One year parts warranty only. If any issues occur contact the factory
immediately for assistance at 800.748.0423, 8AM to 5PM EST, Monday through Friday.
Please review all the information in this manual before installation
and operation. Long term, trouble-free service will follow if good
housekeeping and maintenance procedures are followed. Thank you
for selecting Glastender, Inc. products.
• Electrical: 115 Volt AC, 1 Phase, 60 Hz, less than 5 Full Load
Amps. A 9-foot grounded cord is included.
U
ncrating and
S
tart
-U
p
i
nStrUctionS
1. Unwrap power cord.
2. Position the Lighted Liquor Display.
3. Units up to 54" are shipped as a single unit and need no further
assembly, skip to step 4. For units 60" and longer (LLDS
shown):
• Remove six screws from each top, remove tops. (Fig. 1)
• Put the left LLD power cord through the side hole. (Fig. 2)
• Align the two ends of the Lighted Liquor Displays. (Fig. 3)
• Put the power cord into the right LLD. (Fig. 3)
• Secure the tops of the units together with four provided
screws. (Fig. 4)
• Carefully lay both units on back side. Secure the
bottoms of the units with four provided screws.
(Fig. 5) NOTE: LLD3 model requires 10 screws
(provided).
• Plug the power cord into the right LLD. (Fig. 5)
• Carefully upright connected units.
• Reinstall tops with six screws each.
4. Remove clear protective film from plexiglass tops and
discard.
5. Plug into 115 volt AC outlet.
6. Through the power cord side hole, turn the switch ON.
7. Your Glastender Lighted Liquor Display is now ready
for use.
c
hanging a
L
ight
B
ULB
1. Disconnect the electrical power.
2. Unscrew and remove the top.
3. Twist the bulb, and remove.
4. Align the new bulb pins, set in and twist into position.
5. Put the top back in place and secure with screws.
Figure 4
Figure 1
Figure 2
Power cord through
side hole
Figure 3
6 screws for top installation
L
ighted
L
iquor
d
ispLay
i
nstaLLation
& o
peration
i
nformation
- LLd, LLds, LLd3
LLD3
Figure 5
Top - secure units together
with 4 screws
Align ends
Power cord into
right unit
Lay both units on back
side and secure together
with 4 screw holes
Plug in power cord