Brocks Performance Window Link Set (4" Rod) S1000RR (10-14) & HP4 User Manual
Page 2
DOCUMENT ID 992547
Page 2 of 2
7. Install the billet link end into the frame with the stock bolt and torque to
73.5 lb-ft (100 Nm).
8. Adjust the length of the links to align the link ends with the bearing race
in the pivot lever. The bolt should easily slide through link ends and pivot.
See Figure 5.
9. Install the stock bolt and supplied spacers, install the nut and torque to
73.5 lb-ft (100 Nm). See Figure 6.
10. Remove jack from under bike.
11. Adjust links to desired ride height. Laser etched “L” /Arrow shows direction to turn wrench to lower bike.
Remember L = LOWER. (Links adjust LONGER to make the bike LOWER. Opposite direction to raise the bike.)
Check the threads in the windows, if threads are NOT showing in all adjustment windows, then DO NOT
OPERATE the bike! Contact
, or call our technical support line for additional
information and/or optional adjustment rod lengths.
12. Measure links to confirm that each side is adjusted to the same length. Once the lengths are confirmed, you can
count the same number of flats on the adjustment rods on each link to adjust ride height.
13. Tighten lock nuts on links. Also note: The L/Arrow also shows the direction to LOOSEN the lock nuts. After ride
height adjustment, snug each lock nut (in the opposite direction of the L/Arrow) to prevent movement during
operation of the bike. DO NOT OPERATE the motorcycle with the lock nuts loose! A drop of Loctite®
Threadlocker Blue should be used on all threads as an added safety measure.
14. Replace the exhaust and any other components removed to install the window links.
WARNING: Chassis adjustments can alter the handling characteristics of any machine, and a
lowered vehicle is more likely to experience obstacle and/or cornering clearance contact
problems, especially with the addition of a passenger.
Brock’s Performance Products are designed for Closed-Course Racetrack use ONLY!
For more information, go to
www.BrocksPerformance.com
; click: Installation Instructions.
If you have questions, you can e-mail us at
, or call the office at 937-912-0054.
For Brock’s Performance Products policies and warranty information, go to
www.BrocksPerformance.com
; click: Policies.
Figure 6
Spacers
Adjust
Figure 5
Align