Argus Camera DC2700 - Manual (Page 24)

Argus DC2700 Camera User Manual
Page 24 of 28
A A p p p p e e n n d d i i x x I I – – T T r r o o u u b b l l e e S S h h o o o o t t i i n n g g s s
Troubles Solutions
1 Fail to establish a USB connection.
✁
Check if the USB connection between the
computer and the camera has been established.
✁
Check if the camera is ON
✁
Make sure your computer is operated with
Windows 98 (versions 2) or higher versions.
2 Fail to view images from MyCamera,
PC Host Software.
✁
Make sure USB connection is established before
powering up the camera and opening the
“ MyCamera” .
✁
You may press “ F5” (Refresh) to see if the
problem has been fixed.
3 Deleting MyCamera.
✁
Go to “ Control Panel” of your PC ->
“ Add/Remove Programs” , select “ MyCamera”
from the list and click “ Add/Remove” .
MyCamera will then be deleted.
4 Abnormal and distorted images shown
on Cyber Display
✁
Improper handling (e.g. crashing) of the camera
would cause a sudden bad contact of battery
circuitry.
✁
Disconnecting USB while the camera is ON
would cause a hang-like phenomenon.
✁
Open the battery door and close it again will
solve the problems.
5 Cyber Display turns “ RED”
✁
Low Battery power would cause the Display to
turn RED. Replace the batteries will enable the
Cyber Display to function properly again.
✁
Alkaline batteries are recommended.
6 Camera takes lesser pictures than
suggested
✁
Please see the table, “Suggested Numbers of
picture at different JPG and FORMAT mode” to
see if you are justifying under same condition.
✁
Corrupted image files may consume internal
memory storage. Please go to “REVIEW” of
main menu, select “DELETE ALL” or you may
format the memory storage directly (“MENU” ->
“SETUP” -> “FORMAT ” ) to eliminate the
corrupted files.