Edsal TRB6012 - Manual

Instructions : Welded Bulk Storage Tire Rack Instructions : Welded Bulk Storage Tire Rack Instructions : Welded Bulk Storage Tire Rack
Should you have any comments, damage, missing parts, or problems with assembly of this unit please feel
free to contact our Edsal manufacturing facility at, (773) 475-3000 and request customer service.
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description - Location Purchased - Date Purchased
General Instructions General Instructions General Instructions
Safety Instructions Safety Instructions Safety Instructions
Edsal Welded Bulk Storage Tire Rack is engineered to offer maximum flexibility as well as ease and quickness of as-
sembly. The units can stand individually, or be joined together using the common post. Individual beams can be ad-
justed without disturbing the beams in adjoining units. These instructions should be followed exactly. All parts supplied
must be used as shown. Any alteration or deviation from this instruction sheet can result in unit failure. After the unit is
assembled, it must be placed on a level surface for safety, and optimal product performance.
This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product per-
formance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER !
DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.
Use care and the proper attire when working with metal parts.
Assembly Instructions Assembly Instructions Assembly Instructions
Industrial Products Division
Edsal Manufacturing Company
4400 South Packers Avenue
Chicago, IL 60609
www.edsal.com
Figure 3
Starter Add-On
Figure 2
Attach the beams to the welded end frames as seen in figure 1.
Use both welded end frames to establish the left and the right
sides of the units. After a beam has been placed to the end
units, tap down with a hammer to help drive the beam end clip
tabs into the end frame post slots. To secure the beam to the
end frame, insert the plastic canoe clips through the hole in the
beam bracket and into the frame (see figure 1).
Note: If the beam end clip tabs become bent due to mis-
handling. It may be necessary to adjust the tabs back to
their proper form.
Tires can now be added to each level (see figure 2). Each end
frame can be used as a common end, add on units can be pur-
chased to expand tire storage capacity (see figure 3).
Figure 1
End Frame Post
End Frame Post Slots
Canoe Clip
Beam
Beam End
Clip Tabs
Model (s) :TRB6012 - TRB6042 - TRWS6018 - TRWS7218 - TRWS9618 - TRWS6018 - TRWS7218 - TRWS9618