Alliance Laundry Systems 201959R1 - Manual (Page 14)

-14-
201959
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To Clean the Dispenser
Remove the dispenser housing from agitator by
squeezing the lower part of the dispenser, pulling
directly upward and at the same time tilting
slightly. This will expose the dispenser cup, which is
also removable, for cleaning (refer to illustration).
Both housing and cup can be soaked in hot soapy
water and rinsed clean. The funnel shape in top of
agitator also needs to be cleaned. The hole and the
slots in the two rings will require using a small brush
for proper cleaning.
After cleaning, install dispenser cup, then push
dispenser housing directly downward onto top of
agitator until firmly snapped together.
Use Tips
• Fabric softener spilled onto garments may
cause staining. To remove, dampen stain and
rub with bar soap. Wash as usual.
• Liquid fabric softeners will be dispensed during
the final rinse and should not be combined with
bleach, bluing, starch, detergents, soaps or
packaged water conditioners.
• Fabric softener is not to be used in dispenser
when using Prewash cycle, if available.
• When adding detergent to wash water, do not
allow any to enter into softener dispenser cup,
as softener will become gummy.
To prevent softener buildup, the dispenser can be
filled with clean water for automatic cleaning. This
can be done in washing cycles other than when
softener is used.
Agitator Cap
IMPORTANT: If your washer comes with an
agitator cap, the cap must be on at all times.
TLW2001N
Dispenser Housing
Dispenser Cup
Agitator
TLW2001N