Avaya P117F(R) - Manual (Page 7)

Chapter 2
Installation
Setting the DIP switches
First, set the DIP switches. The position of the switches depends on the application.
The drawing below shows the default positions of the DIP switches on the rear
panel of the P110 switch.
Figure 1 The P117F(R) Stackable Switch Rear Panel Showing the
DIP Switches in their Default Positions
• LSV – Last SW Version: The on-board agent of the P117F(R) can use either the
latest downloaded software or a “Basic” version. The Basic version is factory
loaded.
Ensure the Use Switch is set to the OFF position.
Once you have set the DIP switch, you may proceed with the physical installation
of the switch.
Table 1 DIP Switches on the P117F(R) Stackable Switch
Switch Function OFF ON (Default)
LSV Last SW Version Use the “Basic”
software
version. This is
known as
Bank A Use the latest
downloaded
agent software.
This is known
as Bank B
USE SWITCH Not applicable, for future use only
P117F(R) Stackable Switch Installation Guide 5