Australian Monitor VS88l User Manual
Page 4
F R O N T & R E A R PA N E L
PA G E 4
V S 8 8 I N S TA L L AT I O N & O P E R AT I O N M A N U A L
1
2
REAR PANEL
FRONT PANEL
POWER ON SWITCH
This power switch turns the unit on and off. The
inbuilt LED will illuminate red to indicate that the
switcher is ON and is receiving power
SOURCE SELECT BUTTONS
A separate UP and DOWN source select button is
provided for each destination output. A 7 segment
LED display will indicate the input source number
assigned to a destination output. Any input source
can be assigned to any number of destination
outputs
IR
SENSOR
The IR sensor receives IR commands from the
supplied remote control. To use the supplied
remote control, point the remote control at the IR
sensor
1
2
3
3
1
2
3
4
SOURCE INPUT CONNECTORS
Eight source inputs are provided, each featuring:
• One stereo unbalanced line level inputs
on a dual RCA connector
• One composite video input on a single
RCA
connector
DESTINATION OUTPUT CONNECTOR
Eight destination outputs are provided, each
featuring:
• One stereo unbalanced line level outputs
on a dual RCA connector
• One composite video output on a single
RCA
connector
The selected input source is routed to the respec-
tive destination output.
RS232
Serial RS232 control port to allow for interfacing to
a PC, Crestron or similar third party control system
DC POWER INLET
The VS88 AV matrix switcher is fi tted with a DC
power plug-pack input connector. Please ensure
that the plug-pack used is of an approved type and
is of suffi cient current carrying capacity with the
correct voltage and connector polarity. 12Volt DC
power supply. 1.2A Max.
1
2
3
4