Australian Monitor Zone Mix 3 - Manual (Page 6)

6
INSTALLATION SERIES
Australian Monitor
2. PROG TRIM
3. MIC/LINE CONTROLS
ZONE OUTPUT SECTION
4. EQ
5. STATUS
6. REMOTE
7. MIC/LINE Control
7a.SELECT
7b.LEVEL
These four pots control the input trim of the corresponding program inputs. There is no
gain from these pots.
There are two Mic/Line inputs. The following controls are duplicated for each input.
The zone eq is 5 band with frequency centres at 100Hz, 300Hz, 1kHz, 3kHz and 10kHz.
There is +/- 9dB of cut and boost. The eq is internally defeatable, see Internal Adjustments
on page 10.
This LED gives an indication of OUTPUT signal . It glows green at -30dB and red at 0dBV (1V).
This is meant
indicate clip within the ZoneMix3. When used with Australian Monitor Synergy
amplifiers, both LEDS on the ZoneMix3 and the Synergy amplifier will go red simultaneous
indicating system clip (with pot at full on amplifier).
This LED indicates that the zone is in remote control mode. The program select and
volume on the front panel are disabled and are now controlled by the optional remote
control panel ZM3R, see Remote Control Panel on page 18.
These two push button switches are used to select either or both of the two MIC/LINE inputs
to this zone.
This pot controls the mixed level of the two MIC/LINE inputs in this zone.
Gain
Bass
Treble
8. PROGRAM Control
8a.SELECT
8b.LEVEL
9. POWER Led
This controls the gain of the Mic (on the XLR) or Line (on the RCA) input.
There is +/-12dB of cut and boost at 100Hz. This eq is shelving type.
There is +/-10dB of cut and boost at 10kHz. This eq is shelving type.
to indicate clip within the system (ie when the amplifier is clipping) rather
than
This rotary 5 way switch is used to select which program input is selected to this zone.
This controls the level of the program in this zone.
This LED indicates there is power to the unit.