APG Cash Drawer Series 6000 - Manual

SERIES 6000C CASH DRAWER
OPERATING & MAINTENANCE
INSTRUCTIONS
This instruction sheet
applies to the Series 6000C
cash drawer products.
GETTING STARTED
Prepare a location for the cash drawer. Recommendations for a suitable
location include:
•
A sturdy, level surface no less than the size of the cash drawer;
•
Operating temperature from 20° F to 100° F (-7° C to 37° C);
•
Non-condensing relative humidity from 20% to 80%.
LOCK FUNCTIONS
Two keys are included with each cash drawer for the manual lock. The key
lock provides four functions: locked open, manual open, electrically on-line,
and locked closed. See Figure 2. The key may be removed in the 12 o’clock
(Electrically On-Line), 3 o’clock (Locked Open), or 9 o’clock (Locked
Closed) positions. To reduce the risk of damaging or breaking the key, avoid
leaving it in the lock during normal operation.
Figure 2
PARTS AND ACCESSORIES
Contact your supplier for parts and accessories for your cash drawer.
REMOVING THE DRAWER
Open the cash drawer and remove the plastic coin and bill tray. Grasp the
drawer by the plastic front and lift the drawer up until it stops. Firmly pull
the drawer out at an inclined angle. See Figure 3.
Figure 3
Caution: Be careful not to damage the lock rod mounted on the bottom of
the drawer.
REPLACING THE DRAWER
Mate the outer slides (mounted to the drawer) with the inner slides (mounted
in the cash drawer housing). Lift the drawer up until it stops, and begin to
push the drawer into the cash drawer housing. See Figure 3. When the
strike plate on the back of the drawer has cleared the stop plate in the base,
let the drawer rest in the horizontal position. Push the inner drawer to the
fully closed position. There will be additional resistance since the ball
bearings do not roll until the slides are fully engaged. When the inner
drawer is fully inserted, verify that the drawer opens and closes properly.
PREVENTATIVE MAINTENANCE
Every six months the cash drawer slides should be cleaned and lubricated.
Using a dry, lint free cloth, wipe out the old grease, along with any
accumulated dirt or debris, from the inner and outer slides. Do not use water
or any type of liquid cleaner. After the old grease has been removed, apply a
thin layer of lithium bearing grease to the inner and outer slides. Spread the
grease out evenly along the slides. In extreme conditions, the slides should
be cleaned and re-greased every three months.
CAUTION: Breaking coin rolls on the plastic cash tray or the plastic
drawer front may cause the plastic to fracture.
Lock Rod
Up and Out
Figure 1
Strike Plate
Stop Plate
Electrically
On-Line
Locked
Closed
Manual
Open
Locked
Open
Key Number
Axx
M-323.DOC Rev -