Rivera Primo Direct Drive Belt Drive - Manual (Page 3)

Route battery cables and solenoid wire
through rear of front motorplate via
chamfered hole in motorplate.Attach
front motor plate to rear motorplate
finger tight with 4 each 5/16-18 x 1 3/8”
bolts and flat washers supplied with a
small amount of blue thread locker.
Fasten front motorplate to motor case
with 4 each 5/16-18 x 1” flathead
countersunk bolts supplied finger tight
using blue thread locker. Make sure the
front motor plate is fully seated against
the rear motorplate and the motor case.
Now tighten all bolts on front and rear
motor plate to applicable torque values.
(5/16” shcs = 415 inch pounds, 5/16”
flathead shcs = 190 inch pounds.
(SEE FIGURES 4 & 5)
FIGURE 4
FIGURE 5
Ring gear will already be attached to
ring gear carrier from mfg. Front pulley
insert is mounted loose in ring gear
carrier with bolts loosely threaded in
insert. Install ring gear carrier
assembly with front pulley insert by
holding the bolts and sliding
over sprocket shaft. Now remove 5
bolts from carrier.
(SEE FIGURES 6 & 7)
FIGURE 6
FIGURE 7
3