Comfort-Aire RADS-121G - Manual (Page 3)

2
Heat Controller, Inc. Room Air Remote Controller Owner’s Manual
1
2
3
4
5 Handling the remote controller ......................................................
Remote controller Specifications...................................................
Function buttons .................. .........................................................
How to use the buttons .................................................................
Auto operation..........................................................................................................
Cooling/Heating/Health operation...........................................................................
Dehumidifying operation ........................................................................................
Sleep operation.......................................................................................................
Timer operation ......................................................................................................
CONTENTS
Use the remote controller within a distance of 5
meters from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
Location of the remote controller.
5m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block
the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
Handling the remote controller
2
Sleep CFhil etecrk FoMlleow
Auto On/off Fan High Med Low
ESnaevregry
on off Timer Auto
Fan Cool Dry Mode
TEMP/TIMER
TEMP/TIMER
Heat
5
5
6
6
7
The remote controller is powed by two dry batteries(R03/LR03X2) housed in the rear
part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new batteries,placing the(+) and (-) ends
correctly.
(3) Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all programming.
After inserting new batteries, the remote controller must be reprogrammed.
Replacing batteries
MODE
TIMER
SPEE D
ONE TOUCH
SLEE P
Using the remote controller
Use the remote controller within a distance
of 16 ft (5m) from the appliance, pointing it
towards the receiver. Reception is confirmed
by a beep when a button on the remote
controller is pressed.
onto
AAA batteries (RO3/LRO3X2) housed in the rear
of the remote’s housing and protected by a cover.