Silverline 24V Combi Hammer Drill - Manual (Page 9)

8
GB
Maintenance
WARNING: Always remove the plug from the mains power supply before
carrying out any maintenance/cleaning of the charger. Remove the battery
before carrying out any maintenance/cleaning of the drill.
Note: Both the drill and the charger contain no user-serviceable parts.
If the device does not perform as outlined in this manual, return it to an
authorised Silverline service centre for repair.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the machine’s service life. Clean the
body of your machine with a soft brush, or dry cloth. If available, use
clean, dry, compressed air to blow through the ventilation holes
Storage
• Store this tool carefully in a secure, dry place out of the reach of children.
Store in its original case if a case is provided
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, batteries, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools or batteries
Problem Possible cause Solution
Red charging LED does not
flash and Battery (5) not
charging
Battery not fully seated Clean battery socket of battery connector
Charger not powered Recheck mains connection
Battery has low capacity
Battery not being fully charged Wait until red LED is continuously illuminated and not flashing
Battery charged days before use Charge the previous day or same day as use
Battery has been charged over 100 times and
capacity has started to reduce
This is normal for batteries. Contact your Silverline dealer to purchase
a replacement battery
Drill cannot be switched on
(Trigger (7) does not move)
The forward/reverse switch may be in the middle
(“locked”) position
Slide the forward/reverse switch either to the left or right
Drill does not start when Trigger
is pressed down
Battery completely discharged Recharge battery or replace with a fully charged battery
Defective battery Purchase new battery
Drill defective Contact your Silverline dealer or authorised service centre
Screws do not reach deep
enough into the workpiece
Not enough torque; Torque Selector (3) setting
too low
Choose a higher torque setting
Low battery voltage Recharge battery or replace with a fully charged battery
Screws are driven too deep into
the workpiece surface
Too much torque; torque selector setting too high Choose a lower torque setting
Troubleshooting
236096_Z1MANPRO1.indd 8 19/08/2013 16:16