Silverline 135W Detail Palm Sander 140mm - Manual (Page 9)

8
GB
Symptom Possible cause Solution
No function when On/Off
Switch (5) is operated
No power Check power supply
Defective On/Off Switch
Have the On/Off Switch replaced by an authorised
Silverline service centre
Slow material removal Sanding sheet too fine or worn Fit new sanding sheet with coarser grit
Scratches on workpiece
after sanding
Sanding sheet too coarse Fit new sanding sheet with finer grit
Not enough material removed Continue sanding
Burn marks on workpiece
Sanding sheet incompatible with material Fit correct sanding sheet
Too much pressure exerted on to the sander Use less pressure whilst moving the machine
Excessive dust emission
Vacuum dust extraction system not connected, or
extraction system not switched on
Check connection of the vacuum hose, and ensure dust extraction
system is switched on
Dust extraction not working; sanding sheet not aligned
with dust extraction holes in the Sanding Base; extraction
holes blocked
Realign sanding sheet; unblock dust extraction holes
Troubleshooting
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
243009_Z1MANPRO1(New Version1).indd 8 25/11/2013 11:29