Alto-Shaam PLATINUM SERIES ASC-2E - Manual (Page 15)

o P E R A t I n G I n S t R U C t I o n S
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 13
a. PRESS MaIN POwER Q “on.”
• The display 2 will alternate between last
Cook Set Temperature and actual Cavity
Temperature.
• The oven will preheat to previous Cook
temperature, and the PREhEaT Indicator 1
will illuminate.
To terminate procedure,
press StARt/StoP key L twice.
B. If ThE PREvIOuS cOOk cyclE IS
ACCEPtAblE, PRoCEEd to StEP C.
1.
to Cook by timE
:
• Press Cook H
• Press lit TIME Key J
• Confirm fan speed.
• Adjust the cooking temperature with the
UP or DOWN arrow keys C.
Note: The TIME Indicator D will remain lit.
2.
to Cook by probE
(
optionAl
):
• Press Cook H
• Press lit PRobE Key I
• Confirm fan speed.
• Adjust the cooking temperature with the
UP or DOWN arrow keys C.
Note: The PRobE Indicator F will remain lit.
Note: If more than 5 seconds elapse
before a decision is made, the mode button
must be pushed again to continue.
c. whEN ThE cOOk PREhEaT TEMP. haS
BEEN REachED:
• The StARt Key L and REAdy Indicator A
will flash.
• The control will produce an audible beep every
30 seconds.
1. lOaD PRODucT IN a TIMEly MaNNER.
a.
to Cook by timE
:
• The display B will alternate between
cook cycle temperature and remaining
cooking time when cooking by TIME.
b. to Cook by probE ( optionAl ):
• If cooking by probe, remove probe from
its bracket, wipe the probe tip with a
disposable alcohol pad and properly insert
probe into product.
• The display will alternate between set
cooking temperature, probe temperature,
and elapsed time when cooking by PRobE.
2. clOSE ThE OvEN DOOR -- PRESS
StARt kEy.
3. afTER cOOk cyclE IS cOMPlETE aND
PRodUCt IS REAdy:
• The display will indicate “DONE”.
• The StARt/REAdy indicates will flash,
and the oven will beep every 30 seconds.
4. REMOvE PRODucT PROMPTly TO
AvoId ovERCookInG.
To terminate procedure,
press StARt/StoP key twice.
D. cOOlINg ThE OvEN:
• Open door.
• Press Cool down key P.
1. Cool ContinuouSly
• Fan will run continuously.
• Shut off POWER to terminate.
2.
SEt Cool down tEmpErAturE
• Set desired cool down temperature with
UP/down arrows C. The cool down
temperature ranges from 80° to 450°F.
• Fan will run continuously.
• When the desired cool down temperature
is reached, “COOl/STOP” will light on
the lED, and the oven will beep every
30 seconds.
Note: If more than 4 seconds elapse
before a decision is made, the mode button
must be pushed again to continue.
notE: StARt/StoP
key will stop fan, and
terminate the COOl/DOWN feature.
E. aT ThE END Of ThE Day, ShuT Off OvEN
POwER BEfORE lEavINg ThE PREMISES.
E l E C t R o n I C C o n t R o l o P E R A t I o n