SawStop Mobile Base Conversion Kit - Manual (Page 4)

4. Take the rear support assembly and move it forward until the two mounting holes align with the next set of holes
in the mobile base frame, as shown in Fig. 4. Mount the rear support assembly to the mobile base frame with
two new M8 x 15.7 shoulder socket screws from the hardware bag. Fully tighten the two M8 x 15.7 shoulder
socket screws with a 5 mm hex key.
Raise
1. N ever pla ce fin ger s, t oes or oth er
body parts under
the mob ile b ase.
2. Alway s us e th e saw and the
mob ile
base on a leve l su rfa ce.
3. D o no t con tinue to step on the foot
pedal o nce the uppe
r limit is rea ched.
4. L ower the s aw befo re us e. N ever use
the sa w when it is raised off
the floor . ! WARNING
Never place finger
s,
toes or other
body parts
under the mobile base.
! WARN ING
Never p
lace fin
ger s,
toes o
r o ther b ody parts
und er th e mo bile b as e.
! WA RNING
Lower
3 SawStop Mobile Base Conversion Kit
move the rear support
assembly forward until the
two mounting holes align
with the next set of holes
in the mobile base frame
Fig. 5a
Fig. 4
Assembling Your Mobile Base
Never place fingers, toes or other body parts under the mobile base.
! WARN
ING
Raise
. Never place f
inge rs, toes or
othe r
body parts u
nder the mobile
base.
2. Always use
the saw and the mo
bile
base o n a level surface.
3. Do not continue
to st ep on the foo
t
pedal once the up
per limit is reach
ed.
4. Lower th
e saw before u
se. Ne ver use
the saw when i
t is raised off the f
loor . ! WARN
ING
Low er
Fig. 5b
5. Locate the two conversion linkage bars and the remaining four M8 x 15.7 shoulder socket screws. Use two of
the M8 x 15.7 shoulder screws to install one of the conversion linkage bars on the left side of the mobile base
(see Fig. 5a). The screws pass through the clearance holes in the conversion linkage bar and thread into the
corresponding holes in the rear support assembly and the front bell link. Use the remaining two M8 x 15.7
shoulder socket screws to install the other conversion linkage bar on the right side of the mobile base (see
Fig. 5b). Fully tighten all four screws using a 5 mm hex key.
M8x15.7 shoulder
socket screw
M8x15.7 shoulder
socket screw
M8x15.7 shoulder
socket screws
M8x15.7 shoulder
socket screws
install a conversion
linkage bar on the left
side of the mobile base
install a conversion
linkage bar on the right
side of the mobile base
front
bell link
new
mounting
hole
original
mounting
hole
new
mounting
hole
rear support
assembly