SawStop Industrial Mobile Base - Manual (Page 3)

To safely place the saw into the mobile base, you will need at least four people to lift the saw off the floor and
then lower it onto the mobile base. Have one person lift each corner of the cast iron table top. If your saw has
an extension table, have the two people on the right side of the saw lift on the extension rails near the outer
corner of the cast iron extension wing, not at the end of the extension table.
If a fifth person is available, it may be easier to have four people lift the saw and the fifth person slide the base
under the saw.
Make sure the mobile base is centered
underneath the table saw and that the
foot pedal is in the front. The saw should
sit on the two “straps” on the interior of
the mobile base, and the front of the
cabinet should be touching the inside of
the front face of the mobile base frame
(see Fig. 1).
Your mobile base has been engineered
to lift saws with or without extension
tables. You do not need an additional
arm extending out from the mobile base
to support the extension table.
Never place fingers, toes or other body parts under th
e mobile base. ! W AR NIN G
1. Never place fingers, toes or other body parts under the mobile base. 2. Always use the saw and the mobile base on a level surface. 3. Do not continue to step on the foot pedal once the upper limit is reached. 4. Lower the saw before use. Never use the saw when it is raised off the floor.
! WARNING
Low
Raise
Never place fingers, toes or other body parts under the mobile base.
! WARNING
1. Never place
fingers, toes or other
body parts under
the mobile base.
2. Always use the sa
w and the mobile
base on a level surfa
ce.
3. Do not conti
nue to step on the foot
pedal once the upp
er limit is reached.
4. Lower the saw
before use. Never use
the saw when it is rai
sed off the floor
.
! WARN
ING
Lower
Raise
1. To move your saw with the mobile base, step down on the foot pedal several times to raise the saw off the floor
and onto the wheels (see Fig. 2). Do not raise the saw higher than necessary to move it. Instead, raise the saw
only enough to provide sufficient ground clearance. Do not continue to step on the foot pedal once the upper
limit is reached.
2. Push the saw to its desired location.
3. Step down on the left side of the release
lever to lower the saw back to the floor
(see Fig. 2).
SawStop Industrial Mobile Base 2
Using Your Mobile Base
How to Place the Saw in the Mobile Base
Fig. 2
release lever -
step here to
lower
foot pedal -
step here to
raise
Fig. 1
straps that
support the
saw
the front of cabinet
should be touching
the inside of the
front face of the
mobile base frame