Muxlab Multimedia 16 x 16 Matrix Switch - Manual (Page 18)

© MuxLab Inc. Multimedia 16x16 Matrix Switch Installation Guide
Page 18
3.8. Cloning EDID
In order to clone the EDID of a display, follow the procedure listed below with the
cloning kit included with each Multimedia 16x16 Matrix Switch:
1. Power up the EDID Emulator/Learner with the adaptor provided.
2. Plug the DVI to HDMI adaptor to the DVI output of the EDID Emulator/Learner.
3. Plug the HDMI connector to the display device that you wish to clone.
4. Verify that the EDID WR switch is set to “Unlock”.
5. Press the “Read” pushbutton. The “Read” LED should illuminate for
approximately 2 seconds.
6. Plug the HDMI connector to the input HDMI port where you want the new EDID
applied.
7. Press the “Write” pushbutton. The “Write” LED should illuminate for
approximately 2 seconds.
NOTE: If both LEDs illuminate after performing an operation, this indicates that
the operation has failed. Perform the operation again, making sure that the display
device you are attempting to clone is powered up.