Chemglass Jacketed Filter Reactors - Manual (Page 3)

www.cglifesciences.com [email protected]
Overhead Stirrer Motor
Air Motor 1/4 HP Vertical Motor
1/4 HP Horizontal Motor Explosion Proof (XP) Motor
The motor is installed on the support frame when shipped. Use the following instructions should you
need to remove or adjust these components.
Components Needed for Overhead Stirrer Motor:
1ea CG-2033-11 1/4 HP Vertical Electric Stirrer Motor
1ea CG-2025-20 Air Motor* (Optional)
1ea CG-2033-31 Digital Electric Stirrer Motor Controller (Only Supplied with 1/4 HP Electric Stirrer
Motor)
1ea CG-2044
Tru-Stir™ Stirrer Shaft Coupling
1ea CG-9253-10 Small Kwik Klamp II
1ea CG-3498-03 90° Support Rod
1. The support frame has a universal motor mount. It can be used with an (vertical or horizontal)
electric, air, or optional explosion proof (XP) motor. The mount automatically centers the motor
directly above the reactor.
2. The 1/4 HP electric motor is shipped attached to the support frame via four socket head cap
screws.
3. When using the 1/4 HP electric motor, the digital controller, with mounting bracket on back
panel, needs to be mounted on the S.S. upright. Use the small Kwik Klamp II and the 90°S.S.
support rod to mount the controller to the support frame. Tighten all knobs securely.
*The Air Motor requires the air supply be filtered and a lubricator be installed between the air source
and motor. Filter-Regulator-Lubricator (CG-2025-10) is available separately.