ILY Blu-ray/DVD/CD Duplicator - Manual (Page 10)

9
6. Select Source – This command will allow you to change the source drive to any one of
the drive(s)
inside the unit, including the HDD (if installed).
To change the source drive inside the unit to a different drive:
1. Power on the machine (if not already on).
2. Use the Scroll buttons to select the “6. Select Source”: Press the ENT button.
3. The current Source Drive will be displayed along with the partial model number of the
drive
and the port number in brackets.
4. Use the Scroll buttons to select from other available drives until the port number of
the desired
drive is displayed.
5. Press the ENT button. The desired drive will then become the Source Drive.
 Press ENT 
 Display current Source
Drive setting 
  or 
to select drive
 Press ENT to finish Setting
7. Utility – This command contains various tools to check functionality of the drive(s),
information of the components, and other system information.
7.1 Information
7.1.1 Disc Info: Checks the capacity and space used on the disc(s) inside of the drive(s) of
the duplicator.
7.1.2 Drive Info: Checks the make, model, firmware and the channel (port) of the
drive(s) that are connected to the duplicator.
 Press ENT 
 Press  or  to select
different Drives

  or  and press ENT to set audio CD
burning speed 

  or  and press ENT to
set DVD burning speed 
 Finish
and return to
main menu
 Press ENT 