Audiovox VOD701 - Manual (Page 8)

Figure A
1) Make the connections to the vehicle for the 12 pin wiring harness and battery wire.
2) Open the cover to gain access to Mini-Din Connector on main PCB.
3) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on
the main PCB and into the Mini-Din Connector on the main PCB.
4) Pull the wire tie loop tight and cut off the excess.
5) Connect the 12 pin harness to the mating connector on the Video Monitor.
6) Connect the wired headphone to the remote headphone jacks to the video monitor if those options are
being included.
7) Connect the 14 Pin wire to the FM modulator.
8) Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.
9) Verify all functions of the System before final mounting of the finished assembly.
Note: A VCP or other A/V Component can be connected to the video monitor system using a second
source component harness (purchased separately, part number: 8010730). This second harness would
plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1= VCP or VCP with TV Tuner (Right Mini-Din on main PCB)
2= 2 nd VCP (or game or DVD, etc.…. left Mini-Din)
3= AUX-IN (VCP, Game or future DVD etc...)
4= Built-in DVD
-6-
VOD701
FM
Modulator
Dash Radio
12 VDC Power and Ground
Hard Wired FM Modulator Output
Am/Fm
Antenna
Satalite
Radio TO
FACTORY
RADIO
Black
(Ground)
Optional Remote Headphone Stations
Stereo
Headphone Jack
Gray
(Left+)
Green
(Right+)
Stereo
Headphone Jack
Red RCA (Audio Right)
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Yellow RCA (Video)
White RCA (Audio Left)
"Y" Adapter
for use with
Non-Stereo
Installations
Item# 5
Power Connector
4 Pin IR LED:
Window on the Face of the VCP.
Dome Light
Power Source
CHOKE
Auxillary
video display
12 VDC Power and Ground
INPUT
VIDEO
(Yellow)
Line Out-R (Red)
LINE
OUT
VIDEO Patch Cord
RCA-Female
RCA Male to Male
Line Out-L (White)
Line Out-V (Yellow)
TO
OPTIONAL
ADDITIONAL
MONITOR
To Secondary AV Monitor
Accessory
Harness - Optional
(P/N:8010730)
Power Harness
Item #3
Power Harness
Item #3
14Pin FMM Cable
Item #8
2 1
Second IR
Input
Battery 12V
* REFER TO PAGE 8 FOR FURTHER DETAILS