American Power Conversion AP7862J - Manual (Page 11)

Basic and Metered Rack Power Distribution Unit 7
Operation
Display interface
(AP7862J only)
Link - Rx/Tx
10 /100
Status
Serial Port Reset
Press to
select line.
Press and hold
to invert display.
- Warning
- OK
- Overload
 
  
L3 L2 L1
Am
ps
Am
ps

 
 Phase Indicator LED s:
• Indicates the phase corresponding to the current listed in the digital
display.
• Indicates normal (green), warning (yellow) or alarm (red)
condition.
 Control button:
• Press to change the phase of the current displayed on the digital
display.
• Press and hold for five seconds to view the orientation; hold for an
additional five seconds to change the orientation.
• Press to silence an alarm.
 Ethernet port: Connects the PDU to your network, using a CAT5
network cable.
 Status LED : Indicates the status of the ethernet LAN connection and
the state of the Metered PDU.
 Link LED : Indicates whether there is activity on the network.
 Serial port: Access internal menus by connecting this port ( RJ - 11
modular port) to a serial port on your computer, using the supplied
serial cable (part number
940 - 0144 ).
 Display of the current used by the PDU and attached devices:
• Shows the aggregate current for the phase corresponding to the
Phase Indicator LED that is illuminated.
• Cycles through all three phases in 3-second intervals.
 Reset switch: Resets the PDU to its default settings.