Argox OS-214ZIP - Manual (Page 15)

Cutter Mode 11. Close the top cover and turn on the printer or press the
"FEED" button if the printer is already on.
( Installing the cutter, please refer to Appendix II )
Follow the same procedure as "Loading the Media" from
Note:
step 1 to step 8.
The "FEED" button will not drive the printer to cut. The
cutting work can be executed only when the software
9. Thread the media over the platen roller, then route the media
through the slot of the cutter module.
setting is ready.
10. Press down the print head module firmly.
24
Cutter Module
23