Kramer Electronics PT-103V - Manual (Page 7)

Connecting the PT103V 1:3 Video DA
5
5 Connecting the PT103V 1:3 Video DA
To connect the PT103V 1:3 Video DA, as the example in Figure 4 illustrates,
connect the following 1 :
1. Connect a composite video source (for example, a composite video
player) to the INPUT RCA connector.
2. Connect the 3 OUT RCA connectors to up to 3 composite video
acceptors, as follows:
Connect the OUT 1 connector to video acceptor 1 (for example, Display 1)
Connect the OUT 2 connector to video acceptor 2 (for example, Display 2)
Connect the OUT 3 connector to video acceptor 3 (for example, Display 3)
3. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
4. Adjust the output signal level and/or cable compensation equalization
level, if required.
Figure 4: Connecting the PT103V 1:3 Video DA
1 Switch OFF the power on each device before connecting it to your PT103V. After connecting your PT103V, switch on its
power and then switch on the power on each device