Kramer Electronics VM-100C - Manual (Page 7)

Connecting the VM-100C
5
5 Connecting the VM-100C
This section defines how to connect the VM-100C. In particular, how to
connect:
• A single unit (1:10 Video Component Distributor), see section 5.1
• Several units, see section 5.2
5.1 Connecting a Single VM-100C Unit
To connect a single VM-100C unit (1:10 Video Component Distributor), do
the following
1
:
1. Connect a component video source (for example, an HDTV satellite
receiver) to the RCA INPUT connectors.
2. Connect the 10 component video output connectors
2
to up to 10
component video acceptors.
3. Leave the LOOP RCA INPUT connectors unconnected, and push in the
Input Termination button to 75
Ω.
Note: if a loop connection is required, for example, to a local monitor,
plug it into the LOOP RCA INPUT connectors and release the Input
Termination button to Hi-Z.
4. Connect the power cord
3
(not illustrated in Figure 3).
Figure 3: Connecting a VM-100C Unit
1 Switch OFF the power on each device before connecting it to your VM-100C. After connecting your VM-100C, switch on
its power and then switch on the power on each device
2 When less than 10 outputs are required, connect only those outputs of the VM-100C that are required, and leave the other
outputs unconnected
3 We recommend that you use only the power cord that is supplied with this machine