Kramer Electronics VM-4HDCPxl - Manual (Page 6)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VM-4HDCPxl 1:4 DVI Distributor
4
3.3 Recommendations for Best Performance
To achieve the best performance:
•
Connect only good quality connection cables, thus avoiding
interference, deterioration in signal quality due to poor matching,
and elevated noise levels (often associated with low quality cables)
• Avoid interference from neighboring electrical appliances and
position your VM-4HDCPxl away from moisture, excessive
sunlight and dust
4 Your VM-4HDCPxl 1:4 DVI Distributor
Table 1 and Figure 1 define the VM-4HDCPxl.
Table 1: VM-4HDCPxl 1:4 DVI Distributor Features
# Feature Function
1 POWER LED The green LED is illuminated when the unit is turned ON
2
EDID
Buttons
READ 1 1. To show the EDID status, press READ
2. To acquire the EDID, press the EDID SELECT button, then
press READ
3 SELECT Press to select the EDID mode (One Output, Default or Auto-
mix)
4 OUTPUT STATUS LEDs
(from 1 to 4)
LEDs illuminate when an output(s) is connected and active;
LEDs flash to indicate the type of EDID acquired (see section 7 )
or when a non-HDCP display is connected while HDCP content
is provided to the VM-4HDCPxl
5 INPUT DVI Connector Connects to the DVI source
6 OUTPUT DVI Connectors Connects to a DVI acceptor (from 1 to 4)
7 FOR PROGRAMMING
9-pin D-sub Port
For service use only (see section 7.4 )
8 Power Connector with
Fuse
AC connector enabling power supply to the unit
9 POWER Switch Illuminated switch for turning the unit ON or OFF
1 Illuminates when configuring the EDID