Kramer Electronics VP-222K - Manual (Page 7)

Connecting the UXGA Switcher / DA
5
5 Connecting the UXGA Switcher / DA
To use your VP-222K UXGA Switcher / DA, as illustrated in Figure 2,
do the following:
1. Connect the OUTPUT 1 15-pin HD (F) connector to the acceptor 1 (for
example, a display) and the OUTPUT 2 15-pin HD (F) connector to the
acceptor 2.
2. Connect the source A (for example, a PC) to the INPUT A 15-pin HD (F)
connector and the source B to the INPUT B 15-pin HD (F) connector.
3. Connect the 5V DC power adapter to the power socket and connect the
adapter to the mains electricity.
4. Set the A/B button, as follows:
Release the A/B button to route the INPUT A signal via the
OUTPUT 1 connector to the acceptor 1 and via the OUTPUT
2 connector to the acceptor 2, simultaneously
Push in the A/B button to route the INPUT B signal via the
OUTPUT 1 connector to the acceptor 1 and via the OUTPUT
2 connector to the acceptor 2, simultaneously
Figure 2: VP-222K UXGA Switcher / DA Connections