Kramer Electronics VS-202YC - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Flash Memory Upgrade
12
9. Click Run.
After each stage of the operation is completed, the check-box for that stage
becomes colored green 1 .
When the operation is completed, all 4 check-boxes will be colored green and
the status bar message: Memory Verify Pass appears 2 :
VS202YC.hex
A
Figure 14: Atmel – Flip Window (Operation Completed)
10. Close the “Atmel – Flip” window.
11. Disconnect the power to the
VS-202YC.
12. Disconnect the RS-232 rear panel port.
13. Switch to OFF on the machine underside.
14. Connect the power to the
VS-202YC.
1 See also the blue progress indicator on the status bar
2 If an error message: “Not Finished” shows, click Run again