Kramer Electronics TailorMade - Manual (Page 19)

19
K R A M E R
E lectron ics
MATRIX ROUTING SWITCHER
Four layers can work simultaneously, and each one
can have a different size.
7.4.1.1 Names and Connectors capture.
Click on the box of a source or destination object.
This window opens :
Enter the name of the object, or select it in the list.
Each new name will be automatically added in the
list. This is easy to get it again for other object with
the same name in another column or layer.
If an object with the same name exist in the current
column, Matrix_Op4 will ask you if you want to
remove the existing one.
Choose the number of the connector of your object
in each layer. This will be useful the find easily
your objects on the connexion board.
7.4.1.2 Remote Control Panels programmation.
In the combobox “Remote panel key number” :
Indicate the number of the touch you want to
assign.
7.4.1.3 Assignments Upload.
When the assignments are defined, you can upload
the datas to the EEPROM of the matrix for the
remote control panel to get autonomy and be
independent of the computer. Select the menu
“Matrix / Upload EEPROM”.
7.5 MATRIX CONTROLLER
7.5.1 General Informations
The mains routine of the software Matrix_Op4
consist to create some crosspoints beetween various
sources and destinations.
Matrix_Op4 don’t use the numbers of the
connectors to the devices, but only the names of
these devices. The connections are directly made
beetween the sources and the destinations.
Matrix_Op4 calculates each crosspoint, and returns
the the router, the code containing the layers and
the connectors numbers. As a matter of fact, several
connections can be done with only one operation.
The video, RGB, audio and YC layers can be
following, or separated.
7.5.2 The Switching Display
This mode of display is caracterized by several
personal lines corresponding each one at a
destination, which is identified on the left side. On
the right side, the four sources that are connected
are shown, and can be changed.
7.5.2.1 Selecting and Switching
First, choose a destination by clicking on the line.
Then, a new window opens, with the list of
available sources in each layer :