Kramer Electronics VP-211K - Manual (Page 11)

8 VP-211K - Connecting the VP-211K
Do not connect both the REMOTE IN 1 and the REMOTE IN 2 to
PIN G simultaneously.
Route input 1 to the output, by
attaching PIN IN 1 to PIN G:
Route input 2 to the output, by
attaching PIN IN 2 to PIN G:
Figure 3: REMOTE Terminal Block Connector
4.2 Selecting the Default Master Source Signal
The DEFAULT INPUT switch is factory preset to IN 1 and the VP-211K detects the
presence of the master source signal at the UXGA IN 1 connector. If you connect
active sources to both the UXGA IN 1 and the UXGA IN 2 connectors, the source
at the UXGA IN 1 connector takes priority over the source at the UXGA IN 2
connector and it is routed to the UXGA OUT and the AUDIO OUT connectors
(audio-follows-video).
You can change the default so that the VP-211K automatically detects an active
source signal from UXGA IN 2, by setting the DEFAULT INPUT switch to IN 2.
When active, the source at the UXGA IN 2 connector takes priority over the source
at the UXGA IN 1 connector and it is routed to the UXGA OUT and the AUDIO
OUT connectors (audio follows video).
!