Kramer Electronics VP-27 - Manual (Page 8)

Your VP-27 Presentation Switcher
5
5
Table 1: Front Panel VP-27 Presentation Switcher Features
# Feature Function
1 IR Receiver Signals from the remote control transmitter illuminate the LED
2 POWER LED Lights when the unit is turned ON
3 INPUT
SELECTOR
Buttons
VIDEO (CV) Select the composite video / audio input (from 1 to 4)
4 s-VIDEO (Y/C) Select the s-Video / audio input (from 1 to 4)
5 PC Select the computer graphics video / audio input (from 1 to 4)
6 MASTER AUDIO
SELECTOR Buttons
Y/C Press to route the selected audio signal from the s-Video section to
the master audio outputs
7 CV Press to route the selected audio signal from the composite video
section to the master audio outputs
8 PC Press to route the selected audio signal from the computer graphics
video section to the master audio outputs
9 MIC Press to route the microphone input to the master audio outputs
10
VOLUME
Buttons
MASTER
- Decrease the master audio signal level
11 + Increase the master audio signal level
12
MIC
+ Increase the microphone audio signal level
13 - Decrease the microphone audio signal level
14 MUTE Button Press to disable/enable the Master Audio output
15 TALK OVER Button Press to toggle. When on will activate talk over function
1
16 MIX Button Press to toggle. When on, will mix the microphone signal with the
Master Audio output
17 LOCK Button Press and hold to lock/unlock the front panel buttons
1 With the TALK OVER button pressed in, speaking into the microphone amplifies the voice of the speaker, overriding and
fading out all other audio channels. However, pressing the MIC button in the Master Audio Selector renders the Talk Over
function inactive