Kramer Electronics VP-8x8AK - Manual (Page 51)

Kramer Protocol
47 47
Network settings commands
Set gateway address NET-GATE GATEWAY_ADDRESS
NTGT NET-GATE GATEWAY_ADDRESS RESULT
Read subnet mask NET-GATE?
NTGT? NET-GATE GATEWAY_ADDRESS
Set DHCP mode NET-DHCP DHCP_MODE
NTDH NET-DHCP DHCP_MODE RESULT
Read subnet mask NET-DHCP?
NTDH? NET-DHCP DHCP_MODE
DHCP_MODE =
0 – Don't use DHCP (Use IP set by factory or IP set command).
1 – Try to use DHCP, if unavailable use IP as above.
Change protocol
ethernet port
ETH-PORT PROTOCOL , PORT
ETHP ETH-PORT PROTOCOL ,PORT RESULT
Read protocol
ethernet port
ETH-PORT? PROTOCOL
ETHP? ETH-PORT PROTOCOL , PORT
PROTOCOL = TCP / UDP (transport layer protocol)
PORT = ethernet port to enter protocol 3000 commands.
1-65535 = User defined port
0 - reset port to factory default (50000 for UDP, 5000 for TCP)
Advanced switching commands
Command Syntax Response
Set audio follow
video mode
AFV AFV-MODE AFV AFV-MODE RESULT
Note:
This command effect device front-panel mode and AUD\VID command.
Read audio follow
video mode
AFV? AFV AFV-MODE
AFV-MODE = Front panel AFV mode
"0" or "afv" to set front panel switching buttons in audio-follow-video state.
"1" or "brk" to set front panel switching buttons in their previous state when audio.