Kramer Electronics VS-12DP-IR - Manual (Page 9)

6 VS-12DPIR - Connecting the VS-12DPIR
4 Connecting the VS-12DPIR
Always switch off the power to each device before connecting it to your
VS-12DPIR. After connecting your VS-12DPIR, connect its power and
then switch on the power to each device.
To connect the VS-12DPIR, as the example in Figure 2 shows, do the following:
1. Connect the DP source (for example, a PC with a DP output) to the INPUT
DP connector.
2. Connect the DP OUT connectors to up to two acceptors, as follows:

DP OUT 1 connector to a display

DP OUT 2 connector to a display
3. Connect the 5V DC power adapter to the power socket and connect the
adapter to the mains electricity (not illustrated in Figure 2 ).
Figure 2: Connecting the VS-12DPIR 1x2 DisplayPort Selector
i