Kramer Electronics VS-162AVRCA - Manual (Page 27)

Operating Your Audio-Video Matrix Switcher
23
23
7.2.3 Switching
You can switch:
• One input to one output (see section 7.2.3.1)
• Several inputs to several outputs (see section 7.2.3.2)
• One input to all outputs (see section 7.2.3.3)
7.2.3.1 Switching one Input to one Output
Pressing an OUT-IN combination when your unit operates in the AT ONCE
mode implements the switch immediately.
To switch one input to one output (AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX Display shows the 2 blinking digits, representing the
present input number connected to that specific output 1
out # x
. If the present
output is clear, the 2 blinking digits 00 appear in the MATRIX Display.
The STATUS Display shows the message:
Where x is the output number
2. Press the appropriate IN button.
The output switches to the input and the MATRIX Display shows the
Input # instead of the blinking digits.
The STATUS Display momentarily shows the message:
out # x
from in # y
Where x is the output number and y is the input number
Pressing an OUT-IN combination when your unit operates in the CONFIRM
mode (and the TAKE LED is lit), requires user confirmation.
To switch one input to one output (CONFIRM mode):
1. Repeat step 1 above.
2. Press the appropriate IN button.
The MATRIX Display shows the 2 blinking digits, representing the input
number and the TAKE LED blinks.
The STATUS Display shows 2
1 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
the message:
2 Continuously, within the limit of the timeout (approximately 30 seconds)