Kramer Electronics VS-41HC - Manual (Page 12)

VS-41HC - Connecting the VS-41HC 9
The PC mode and the DVD mode can be applied to a single unit or to several
inputs. For example, if you want to connect computers to INPUTS 1 and 2, and
DVD machines to INPUTS 3 and 4, set INPUTS 1 and 2 to the PC mode and
INPUTS 3 and 4 to the DVD mode.
To set the inputs to either the PC or DVD mode, do the following:
1. Turn off the VS-41HC power.
2. Press the PANEL LOCK button while turning the power on again.
3. Keep pressing and holding the PANEL LOCK button for a few seconds and
then release it.
The LOCK button flashes.
If an input button illuminates, this indicates that that input is set to the DVD
mode.
If an input button is not illuminated, this indicates that that input is set to the
PC mode.
4. Press an input to toggle between the PC mode (input button not illuminated)
and the DVD mode (input button illuminated).
5. To exit this mode, press the PANEL LOCK button.
6. Connect a computer to the input that is set to the PC mode and a DVD to the
input that is set to the DVD mode.
The following table summarizes the differences between the PC mode and the
DVD mode:
PC Mode DVD Mode
The input is connected to a computer The input is connected to a multimedia
application, such as a DVD, a set top box
and so on
The EDID is available at all times (to prevent
computer reset) The EDID is available only when the input
and an output are connected
The input EDID source is the default EDID
or an acquired EDID (see
Section 5.1 )
The input EDID source is acquired directly
from the connected output