Kramer Electronics VS-66H3 - Manual (Page 10)

Defining the VS-66H3 6x6 HDMI Matrix Switcher
7
Figure 2: VS-66H3 6x6 HDMI Matrix Switcher Rear Panel
Table 2: VS-66H3 6x6 HDMI Matrix Switcher Rear Panel Features
# Feature Function
13 OUTPUT HDMI Connectors (1 to 6) Connect to up to 6 HDMI acceptors
14 INPUT HDMI Connectors (1 to 6) Connect to up to 6 HDMI sources
15 RS-232 9-pin D-sub Serial Port Connector Connect to a PC/serial controller
16 ETHERNET RJ-45 Connector Connect to a PC via a LAN
17 ETH RESET Button Press to reset to the factory default IP parameters 1
18 REMOTE IR Opening 2 Connect to an external IR receiver for controlling the device via an IR remote controller (see
Section 4.1 )
19 Mains Power Connector Connect to the mains power
20 Mains Power Fuse Fuse for protecting the device
21 Mains Power Switch Switch for turning the device on or off
1 First turn the VS-66H3 off and then turn it on again while pressing the ETH RESET button. The device will power up and load its memory with the factory default IP parameters
2 Covered by a cap. The 3.5mm jack at the end of the internal IR connection cable fits into this opening