Kramer Electronics VS-81HDxl - Manual (Page 8)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VS-81HDxl 8x1 HD/SD-SDI Switcher
6
Table 1: VS-81HDxl 8x1 HD/SD-SDI Switcher Features
# Feature Function
1 IR Receiver The red LED is illuminated when receiving signals from the Infrared
remote control transmitter
2 POWER Switch Illuminated switch for turning the unit ON or OFF
3 OFF Button Press to disconnect the outputs
4 INPUT SELECTOR Buttons Select the input to switch to the output (from 1 to 8)
Press IN buttons 1, 2 and 3 simultaneously to reset the machine to
its factory default values
1
(see section 6.4 )
Use to set the resolution when switching genlocked video signals (see
section 6.5 )
5 PANEL LOCK Button Disengages the front panel buttons
6
GE
N
L
OC
K IN BNC Connector Connect to the genlock source
7 TERM Button Press to terminate the genlock source (75
Ω) or release for looping 2
8 LOOP BNC Connector Connect to the GENLOCK connector of the next unit in the line
9 INPUT BNC Connectors Connect to the serial digital video sources (from 1 to 8)
10 OUTPUT SDI BNC
Connectors
Connect the two identical SDI outputs to serial digital video
acceptors (1 and 2)
11 RS-485 Detachable Terminal
Block Port
PIN G is for the Ground connection
3
12
; PINs B (-) and A (+) are for RS-485
RS-232 9-pin D-sub Port Connects to the PC or the Remote Controller
4
13 REMOTE Terminal Block
Connector
Connect to contact closure switches (see section 6.7 )
14 MACHINE ID DIP-switches DIP-switches for setting the machine ID number
15 REMOTE IR Opening
5
Connects to an external IR receiver
6
16
unit for controlling the machine via
an IR remote controller (instead of using the front panel IR receiver)
ETH FACTORY RESET
Button
Press to reset to factory default definitions
7
IP number
− 192.168.1.39
:
Mask – 255.255.255.0
Gateway – 192.168.1.1
17 ETHERNET Connector Connects to the PC or other Serial Controller through computer
networking
18 Power Connector with Fuse AC connector enabling power supply to the unit
1 The 7-segment display shows 12341234, indicating that the operation mode is normal, and that the setups stored via the
INPUT/OUTPUT buttons have been erased
2 Extending the genlock source to another unit
3 The ground connection is sometimes connected to the shield of the RS-485 cable. In most applications, the ground is not
connected
4 Via a null-modem connection
5 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
6 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed), see section 4.1
7 First disconnect the power cord and then connect it again while pressing the ETH Factory Reset button. The unit will power
up and load its memory with the factory default definitions