Kramer Electronics VS-88FO User Manual
User manual
Advertising
Table of contents
Document Outline
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Installing in a Rack
- 5 Connecting the VS-88FO
- 5.1 Installing the SFP Modules
- 5.2 Connecting the RS-232 Port
- 5.3 Connecting a PC or Controller to the RS-485 Port
- 5.4 Switching Genlocked Video Signals
- 5.5 Connecting via Ethernet
- 5.6 Configuring the Ethernet Port Initially
- 5.7 Controlling Using the Ethernet Port
- 5.8 Using the Ethernet Reset Button
- 6 Operating the VS-88FO
- 6.1 Operating the VS-88FO from the Front Panel
- 6.1.1 Power-On Display
- 6.1.2 Using the AT ONCE and CONFIRM Modes
- 6.1.3 Toggling Between Modes
- 6.1.4 Switching in the AT ONCE Mode
- 6.1.5 Switching in the CONFIRM Mode
- 6.1.6 Storing an Input/Output Configuration
- 6.1.7 Recalling an Input/Output Configuration
- 6.1.8 Locking the Front Panel
- 6.1.9 Switching Protocols
- 6.2 Using Serial Commands
- 6.3 Using the Infrared Remote Controller
- 6.4 Upgrading the Firmware
- 6.5 Changing the Device Parameters
- 6.1 Operating the VS-88FO from the Front Panel
- 7 Technical Specifications
- 8 Default Communication Parameters
- 9 Kramer Protocol 3000
- 10 Hex Table (Protocol 2000)
- 11 Kramer Protocol 2000