Kramer Electronics VS-88HD - Manual (Page 13)

Connecting Your VS-88HD 8x8 SD/HD-SDI Matrix Switcher
11
6.4 Genlock Switching
The following Genlock switching procedures apply to firmware version 2.2
and higher.
The
VS-88HD performs switching during the vertical interval according to
the RP168 standard when the Genlock signal is connected with the following
set up:
For NTSC, press and hold the input 7 button for few seconds (the LCD
will flash)
For PAL, press and hold the input 8 button for few seconds (the LCD will
flash)
For 1080i@60Hz, press and hold the input 1 button for few seconds (the
LCD will flash)
For 1080i@50Hz, press and hold the input 2 button for few seconds (the
LCD will flash)
For 720p@60Hz, press and hold the input 3 button for few seconds (the
LCD will flash)
Note that last set up is saved in the non-volatile memory