Alcatel-Lucent 7750 SR OS - Manual (Page 55)

IP Router Configuration
7750 SR OS Router Configuration Guide Page 55
Configuring IPv6 Over IPv4 Parameters
This section provides several examples of the features that must be configured in order to
implement IPv6 over IPv4 relay services.
• Tunnel Ingress Node on page 55
→
Learning the Tunnel Endpoint IPv4 System Address on page 57
→
Configuring an IPv4 BGP Peer on page 58
→
An Example of a IPv6 Over IPv4 Tunnel Configuration on page 59
• Tunnel Egress Node on page 61
→
Learning the Tunnel Endpoint IPv4 System Address on page 62
→
Configuring an IPv4 BGP Peer on page 63
→
An Example of a IPv6 Over IPv4 Tunnel Configuration on page 64
Tunnel Ingress Node
This configuration shows how the interface through which the IPv6 over IPv4 traffic leaves the
node. This must be configured on a network interface.
CLI Syntax: config>router
static-route ::C8C8:C802/128 indirect 200.200.200.2
interface ip-int-name
address {ip-address/mask>|ip-address netmask} [broadcast
all-ones|host-ones]
port port-name
Example : config>router# interface ip-1.1.1.1
config>router>if# address 1.1.1.1/30
config>router>if# port 1/1/1
config>router>if# exit
config>router#
The following displays the configuration output showing the interface information.
A:ALA-49>configure>router# info
----------------------------------------------
...
interface "ip-1.1.1.1"
address 1.1.1.1/30
port 1/1/1
exit
...
----------------------------------------------
A:ALA-49>configure>router#