Kramer Electronics WSI-1VGA - Manual

The
Congratulations on purchasing your Kramer WSI-1VGA Step-in Module which is ideal
for boardrooms and presentation rooms.
Kramer WSI-1VGA Step-in Module
The Kramer WSI-1VGA is a VGA and unbalanced stereo audio, remote control panel
that can, for example, fit into the Kramer TBUS-1A, TBUS-4i or TBUS-5i Table
Connection Boxes (see Figure 3 ). The WSI-1VGA is used for remotely taking control of
a compatible switcher, for example, the VP-81KSi.
Figure 1 and Table 1 define the WSI-1VGA Step-in Module.
Figure 1: WSI-1VGA Step-in Module Front and Rear Panel View
Table 1: WSI-1VGA Step-in Module Front and Rear Panel Features
# Feature Function
1 STEP-IN Button Press to select the switcher input to which the WSI-1VGA is connected
2 PC INPUT VGA 15-pin HD (F)
Connector
Connect to the video source (up to UXGA)
3 AUDIO INPUT 3.5mm Mini
Jack
Connect to the unbalanced stereo audio source
4 Audio Output 3.5mm Mini
Jack
Connect to the unbalanced stereo audio input of the switcher
5 Video Output VGA 15-pin HD
(F) Connector
Connect to the video input of the switcher. (The cable used must connect
all pins, for example, Kramer cable CP-GM/GM or C-GMA/GMA)
Figure 2 shows the wiring connections for the WSI-1VGA.
Figure 2: WSI-1VGA Wiring Connections
To install and connect the WSI-1VGA as illustrated in Figure 2 :
Note: The following steps assume that you have video (with 15-pin HD (M)
connectors) and audio (with 3.5mm mini jacks) cables running from the switcher
inputs to the inside of the TBUS-1A (see Figure 3 ).
1. After removing the required blanking panel, insert the WSI-1VGA into the
required opening of the TBUS-1A.
2. Insert the four screws to secure the module in place and tighten the screws.
3. Connect the video cable in the TBUS-1A to the 15-pin HD video output connector
on the rear of the WSI-1VGA.
4. Connect the audio cable in the TBUS-1A to the 3.5mm mini jack audio output
connector on the rear of the WSI-1VGA.
5. Plug the video source (for example, a computer) into the 15-pin HD PC INPUT
connector on the front panel of the WSI-1VGA.
6. Plug the audio source (for example, a computer) into the 3.5mm mini jack AUDIO
INPUT connector on the front panel of WSI-1VGA.
7. Press the STEP IN button to take control of the switcher input.