1 defining the sl-10 master room controller, Defining the sl-10 master room controller, Figure 1: sl-10 master room controller – Kramer Electronics SL-10 User Manual

Page 8

Advertising
background image

SL-10 - Overview

5

3.1

Defining the SL-10 Master Room Controller

This section defines the SL-10.

Figure 1: SL-10 Master Room Controller

#

Feature

Function

1

ETHERNET RJ-45 Connector

Connects to the PC or other serial controller through
computer networking LAN to control several AV
products over Ethernet

2

DEFAULT Recessed Pushbutton Press to reset to factory default definitions:

IP number

192.168.1.39, Mask

– 255.255.0.0

Gateway

– 0.0.0.0

First disconnect the power supply and then connect it
again while pressing the DEFAULT button. The unit
powers up and loads its memory with the factory default
definitions and erases all stored presets

3

IR Output Terminal Blocks

Connect to IR emitter cables (from 1 to 3)

4

GPI/O Terminal Blocks

Connect to various analog and digital sensors (from 1
to 2)

5

RELAYS Terminal Blocks

Connect to low-voltage relay-driven devices (from 1 to
5)

6

RS-232 Terminal Blocks

Connect to the RS-232 devices (from 1 to 2)

7

RS-485 Terminal Block

Pins B (-) and A (+) are for RS-485; Pin G may be
connected to the shield (if required)

Advertising