Kramer Electronics SP-10D - Manual (Page 9)

Your SP-10D Digital Video Processor
7
# Feature Function
24 HUE Button Press the HUE 1 button and adjust using the + and – buttons
25 V/RED Button Press the V 4 /RED 5 button 6 and adjust using the + and – buttons
26 YUV/RGB LEDs Cycle between the different color spaces of color control: YUV and
RGB. The corresponding LED lights
27 COLOR SPACE Button Press to select the color space of the color control; if the COLOR
SPACE button is not illuminated, color control is disabled
28 STORE Button Stores the current setup in the non-volatile memory
29 RECALL Button Recalls a setup from the non-volatile memory
30 7-segment Display Displays data when using a front panel button
31 - Button Press to decrease the level
32 + Button Press to increase the level
33 FREEZE Button Pauses the output video
34 PANEL LOCK Button Disengages the front panel buttons
Table 2: Rear Panel SP-10D Digital Video Processor
# Feature Function
35
IN
PUT
S
CV BNC Connector Connects to the composite video source
36 Y/C 4-pin Connector Connects to the s-Video source
37 G/Y BNC Connector Connects to the RGB (connect all 3 connectors: G,
B, and R), or YUV (connect all 3 connectors: Y,
B-Y, and R-Y), or RGBS (connect all 4 connectors:
G, B, R and S
2 ) video source
38 R/R-Y BNC Connector
39 B/B-Y BNC Connector
40 SYNC BNC Connector Connects to the external video sync source
41
OUTP
UTS
SPLITTER BNC Connector Connects to the split image acceptor
42 Y/C 4-pin Connector Connects to the s-Video (Y/C) acceptor
43 CV BNC Connector Connects to the composite video acceptor
44 G/Y BNC Connector Connects to the RGB (connect all 3 connectors:
G, B, and R), or YUV (connect all 3 connectors:
Y, B-Y, and R-Y), or RGBS (connect all 4
connectors: G, B, R and any Cs), or RGBHV
(connect all 5 connectors: G, B, R, Hs and Vs)
video acceptor
45 R/R-Y BNC Connector
46 B/B-Y BNC Connector
47 Vs (vertical sync)/Cs 3 BNC Connector
48 Hs (horizontal sync)/Cs 3 BNC Connector
49 SYNC BNC Connector Connects to the genlock source
50 LOOP BNC Connector Connects to the next genlocked unit
51 75 OHMS IN Button Press to terminate the genlock source (75 Ω) or
release for looping 4
52 RS-232 Port Connects to the PC or the remote controller
53 SETUP DIP-switches DIP-switches setup (see section 6.2 )
54 Power Connector with Fuse AC connector enabling power supply to the unit
1 Available in all input and output formats and standards
2 Item 6 below
3 To use Cs (Composite Sync), set Dipswitch 2 ON (see Table 3 for details)
4 Push in to terminate the input. Release when the input extends to another unit