Figure 2: the auto edid button on the 602t, N 4.2, Figure 2 – Kramer Electronics 602R/T User Manual
Page 9: Using a small screw
6
602T, 602R - Using the Two-fiber Detachable Optical DVI System
The EDID LED flashes several times while reading the EDID. The LED turns
OFF after about eight seconds.
5. Disconnect the transmitter from the display.
The LED lights
6. Disconnect
the
602T.
The EDID information is now stored and the Indication LED is on.
Figure 2: The Auto EDID Button on the 602T
4.2
Connecting the Detachable Optical DVI
Transmitter/Receiver
To connect the 602T Two-fiber Detachable Optical DVI Transmitter with the 602R
Two-fiber Detachable Optical DVI Receiver, as the example in
illustrates,
do the following:
1. Set the EDID of the display device (see
).
2. Connect
the
602R to the 5V DC power adapter and connect the adapter to
the mains electricity. The blue LED lights.
3. Connect the duplex LC fiber cables to the 602T and 602R modules, one
cable at a time, as illustrated in
.
Single-mode and multi-mode fiber are applicable up to 500 meters. For distances over
500 meters, use single-mode fibers.
4. Plug
the
602T DVI connector directly to the DVI connector of the computer.
Do not use any intermediate cable or adapter between them, and connect cables 1 and
2 as indicated in
5. Connect
the
602R DVI connector directly to the DVI connector of the display
device.